From 9b5cbf242399bbf3b4f319a71ccf6cbaeea81b78 Mon Sep 17 00:00:00 2001 From: esenapaj <creation0004@gmail.com> Date: Tue, 12 Jul 2016 17:48:40 +0900 Subject: [PATCH] Follow-up the PR #4271 (X_DUAL_STEPPER_DRIVERS) MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit ã»Update a forgotten Configuration_adv.h of K8400 --- .../K8400/Configuration_adv.h | 33 ++++++++++++------- 1 file changed, 21 insertions(+), 12 deletions(-) diff --git a/Marlin/example_configurations/K8400/Configuration_adv.h b/Marlin/example_configurations/K8400/Configuration_adv.h index 12a924d1ff..ba78a15896 100644 --- a/Marlin/example_configurations/K8400/Configuration_adv.h +++ b/Marlin/example_configurations/K8400/Configuration_adv.h @@ -229,11 +229,28 @@ //#define Z_LATE_ENABLE // Enable Z the last moment. Needed if your Z driver overheats. +// Dual X Steppers +// Uncomment this option to drive two X axis motors. +// The next unused E driver will be assigned to the second X stepper. +//#define X_DUAL_STEPPER_DRIVERS +#if ENABLED(X_DUAL_STEPPER_DRIVERS) + // Set true if the two X motors need to rotate in opposite directions + #define INVERT_X2_VS_X_DIR true +#endif + + +// Dual Y Steppers +// Uncomment this option to drive two Y axis motors. +// The next unused E driver will be assigned to the second Y stepper. +//#define Y_DUAL_STEPPER_DRIVERS +#if ENABLED(Y_DUAL_STEPPER_DRIVERS) + // Set true if the two Y motors need to rotate in opposite directions + #define INVERT_Y2_VS_Y_DIR true +#endif + // A single Z stepper driver is usually used to drive 2 stepper motors. -// Uncomment this define to utilize a separate stepper driver for each Z axis motor. -// Only a few motherboards support this, like RAMPS, which have dual extruder support (the 2nd, often unused, extruder driver is used -// to control the 2nd Z axis stepper motor). The pins are currently only defined for a RAMPS motherboards. -// On a RAMPS (or other 5 driver) motherboard, using this feature will limit you to using 1 extruder. +// Uncomment this option to use a separate stepper driver for each Z axis motor. +// The next unused E driver will be assigned to the second Z stepper. //#define Z_DUAL_STEPPER_DRIVERS #if ENABLED(Z_DUAL_STEPPER_DRIVERS) @@ -255,14 +272,6 @@ #endif // Z_DUAL_STEPPER_DRIVERS -// Same again but for Y Axis. -//#define Y_DUAL_STEPPER_DRIVERS - -#if ENABLED(Y_DUAL_STEPPER_DRIVERS) - // Define if the two Y drives need to rotate in opposite directions - #define INVERT_Y2_VS_Y_DIR true -#endif - // Enable this for dual x-carriage printers. // A dual x-carriage design has the advantage that the inactive extruder can be parked which // prevents hot-end ooze contaminating the print. It also reduces the weight of each x-carriage