3DPrinting/MarlinFirmware-Configurations
0
0
Fork 0
mirror of https://github.com/MarlinFirmware/Configurations.git synced 2025-09-17 09:37:57 +00:00
Code Issues Releases Wiki Activity
MarlinFirmware-Configurations/config/examples/BIQU/B1
History
Scott Lahteine 07f1136873 🎨 Swap some LCDs
2024-11-03 14:07:56 -06:00
..
Configuration.h 🎨 Swap some LCDs 2024-11-03 14:07:56 -06:00
Configuration_adv.h ✨ PELTIER_BED (2) 2024-10-13 01:50:10 -05:00
README.md 🔧 Enable MicroProbe V2 on Hurakan (#1007) 2024-02-01 15:27:09 -06:00

README.md

BIQU B1 Firmware

In Configuration.h enable the MOTHERBOARD BOARD_BTT_SKR_V1_4 option at the top to specify the BTT SKR V1.4 motherboard, otherwise the V2.0 board will be applied (slightly farther down).

For the SKR V2.0-based config, flash drive support is enabled by default. Jumpers to enable support may not have been installed correctly from the factory, so follow BIQU's instructions, starting with Step 2 if flash drive support is not working correctly.

BLTouch Probe Support

Uncomment B1_USE_BLTOUCH for probe customization.

This configuration retains the use of homing with a Z limit switch. If you want to home with the BLTouch probe, remove your Z limit switch & bracket and enable (uncomment) USE_PROBE_FOR_Z_HOMING and Z_SAFE_HOMING. Change Z_MIN_ENDSTOP_HIT_STATE from LOW to HIGH.