mirror of https://github.com/MarlinFirmware/Marlin.git synced 2024-11-24 04:29:34 +00:00

History

Bob-the-Kuhn 0934563b97 G38 optional double touch Made the double touch portion a conditional compile based on the PROBE_DOUBLE_TOUCH flag. ============================================== Bugfix The current G38 only stopped a move if it involved the Z axis. Moved all the G38 code to it's own section and put it where it would always be executed no matter what axis was moving or if the endstop was enabled. Also added a comment to configuration_adv to alert the user the double tap had to be turned on. ============================================== Change G38 back to using Z_MIN_PROBE There's no Z_MIN endstop if Z_DUAL_ENDSTOPS is enabled and you have them set to the top of the gantry. G38 started out as using the Z_MIN_PROBE pin. I don't remember why we changed it to the Z_MIN endstop.		2017-03-22 15:08:49 -05:00
..
DUAL	Patch configs UBL followup	2017-03-18 12:32:03 -05:00
Configuration_adv.h	G38 optional double touch	2017-03-22 15:08:49 -05:00
Configuration.h	Update Felix config for UBL	2017-03-19 00:28:48 -05:00
README.md

README.md

Felix 2.0/3.0 Configuration for Marlin Firmware

Bringing silky smooth prints to Felix.

Build HOWTO

Install the latest non-beta Arduino software IDE/toolset: http://www.arduino.cc/en/Main/Software
Download the Marlin firmware
- Latest developement version
- Stable version
In both cases use the "Download Zip" button on the right.

cd Marlin/Marlin
cp example_configurations/Felix/Configuration_adv.h .

The next step depends on your setup:

Single Extruder Configuration

cp example_configurations/Felix/Configuration.h .

Dual Extruder Configuration

cp example_configurations/Felix/DUAL/Configuration.h Configuration.h

Compile Firmware

Start the Arduino IDE.
Select Tools -> Board -> Arduino Mega 2560
Select the correct serial port in Tools -> Serial Port (usually /dev/ttyUSB0)
Open Marlin.pde or .ino
Click the Verify/Compile button

Flash Firmware

Connected directly via USB

Click the Upload button. If all goes well the firmware is uploading

Remote update

Find the latest Arduino build:

ls -altr /tmp/
drwxr-xr-x 5 chrono users 12288 Mar 3 21:41 build6072035599686630843.tmp

Copy the firmware to your printer host:

scp /tmp/build6072035599686630843.tmp/Marlin.cpp.hex a.b.c.d:/tmp/

Connect to your printer host via ssh, stop Octoprint or any other service that may block your USB device and make sure you have avrdude installed, then run:

avrdude -C/etc/avrdude.conf -v -v -v -patmega2560 -cwiring -P/dev/ttyUSB0 \
-b115200 -D -Uflash:w:/tmp/Marlin.cpp.hex:i

Acknowledgements

Mashed together and tested on https://apollo.open-resource.org/mission:resources:picoprint based on collaborative teamwork of @andrewsil1 and @thinkyhead.