mirror of https://github.com/MarlinFirmware/Marlin.git synced 2024-11-30 15:26:18 +00:00

History

Richard Wackerbarth 58941e543e ELB_FULL_GRAPHIC_CONTROLLER_SDCARDDETECTINVERTED removed #defining something just to define something else doesn’t make sense If you want SDCARDDETECTINVERTED, just define it yourself. If the previous code was intended to define, undefined and then again define the term, that code is improper.		2015-06-06 21:44:59 -05:00
..
Configuration_adv.h	Configuration_adv.h: Add FAN_MIN_PWM for slow fan stopping issue …	2015-06-06 20:13:56 -05:00
Configuration_DUAL.h	ELB_FULL_GRAPHIC_CONTROLLER_SDCARDDETECTINVERTED removed	2015-06-06 21:44:59 -05:00
Configuration.h	ELB_FULL_GRAPHIC_CONTROLLER_SDCARDDETECTINVERTED removed	2015-06-06 21:44:59 -05:00
README.md	Fixed path typos in README	2015-03-14 10:18:12 +00:00

README.md

Felix 2.0/3.0 Configuration for Marlin Firmware

Bringing silky smooth prints to Felix.

Build HOWTO

Install the latest non-beta Arduino software IDE/toolset: http://www.arduino.cc/en/Main/Software
Download the Marlin firmware
- Latest developement version
- Stable version
In both cases use the "Download Zip" button on the right.

cd Marlin/Marlin
cp example_configurations/Felix/Configuration_adv.h .

The next step depends on your setup:

Single Extruder Configuration

cp example_configurations/Felix/Configuration.h .

Dual Extruder Configuration

cp example_configurations/Felix/Configuration_DUAL.h Configuration.h

Compile Firmware

Start the Arduino IDE.
Select Tools -> Board -> Arduino Mega 2560
Select the correct serial port in Tools -> Serial Port (usually /dev/ttyUSB0)
Open Marlin.pde or .ino
Click the Verify/Compile button

Flash Firmware

Connected directly via USB

Click the Upload button. If all goes well the firmware is uploading

Remote update

Find the latest Arduino build:

ls -altr /tmp/
drwxr-xr-x 5 chrono users 12288 Mar 3 21:41 build6072035599686630843.tmp

Copy the firmware to your printer host:

scp /tmp/build6072035599686630843.tmp/Marlin.cpp.hex a.b.c.d:/tmp/

Connect to your printer host via ssh, stop Octoprint or any other service that may block your USB device and make sure you have avrdude installed, then run:

avrdude -C/etc/avrdude.conf -v -v -v -patmega2560 -cwiring -P/dev/ttyUSB0 \
-b115200 -D -Uflash:w:/tmp/Marlin.cpp.hex:i

Acknowledgements

Mashed together and tested on https://apollo.open-resource.org/mission:resources:picoprint based on collaborative teamwork of @andrewsil1 and @thinkyhead.