Robert Pelnar
ca33f7f60f
PWM_GRAD back to 4 (trinamic suggested value), standstilltimeout = 1000
2017-09-26 13:07:25 +02:00
michalprusa
5ff28682be
Automatic recovery after crash is detected
2017-09-26 11:48:46 +01:00
Robert Pelnar
40fae26d75
Silent / Hight Power mode switching - wait for standstill
...
parameter tunning:
PWM_GRAD, PWM_AMPL TCOOLTHRS (XY)
2017-09-26 12:22:58 +02:00
Robert Pelnar
345fee66be
Silent mode x-axis amplitude adjust from 200 to 210, because of layershift at high speed.
2017-09-26 07:20:54 +02:00
Robert Pelnar
b475d11bdb
Maker Faire brainstorm 2.0 (2)
...
Automatic recover after short power loss (according to heatbed temperature drop)
Adjusted crashdetection - TMC2130_TCOOLTHRS_X and TMC2130_TCOOLTHRS_Y = 450 to be enabled at low speed
!!!ALL FEATURES TESTED AT THIS POINT!!!
2017-09-26 06:11:42 +02:00
Robert Pelnar
89121e6e34
Maker Faire brainstorm 2.0
...
Added filament sensor and crash detection to EEPROM
Added crash-detection counters display disable directive
Added Restore/Save print directive
Added crash detection and filament sensor settings to Tune menu
2017-09-26 04:30:10 +02:00
Robert Pelnar
39f6e746dc
Crashdetection tunning.
2017-09-26 01:43:56 +02:00
bubnikv
ed0fe01bcc
Decreased the homing feedrate for the X axis from 3000 to 2500mm/min.
...
With the old settings the stall guard did not work reliably.
2017-09-25 15:22:20 +02:00
bubnikv
b0ca2477c8
Modified homing procedures for the X & Y axes using the Trinamic stall guard
...
to run against the end stop with a repeatable velocity.
Slightly reduced the collision detection sensitivity.
2017-09-24 00:07:32 +02:00
Robert Pelnar
480838a0a1
Fixed homing (mbl and babystep - crashdetection recovery work fine now).
2017-09-23 16:35:01 +02:00
Robert Pelnar
d2ff47dac8
Crashdetection
2017-09-22 23:06:52 +02:00
Robert Pelnar
4805713b8d
SG limits adjusted (x=5,y=5), for homing is possible to set different values (x=5,y=5, without filter).
2017-09-22 20:53:00 +02:00
Robert Pelnar
df1aa85526
Crashdetection + configuration file.
2017-09-22 19:28:32 +02:00
PavelSindler
6eb57da770
fan check can be turned off from support menu, saving parameters to eeprom with offset and different levels, fan kickstart,2nd heatbed version, fans check modified
2017-09-21 15:20:02 +02:00
Robert Pelnar
6f5f88e7ea
Temporary added configuration file Configuration_prusa.h.
2017-09-14 16:28:16 +02:00
