Prusa-Firmware/tools
Yuri D'Elia 9958c449e3 elf_mem_map: remove DWARF version except in help
Fix version to DWARF3, which is what we actually support.
2021-07-30 06:38:12 +02:00
..
dump_eeprom Add several low-level debugging tools 2021-07-30 06:38:12 +02:00
dump_sram Add several low-level debugging tools 2021-07-30 06:38:12 +02:00
elf_mem_map elf_mem_map: remove DWARF version except in help 2021-07-30 06:38:12 +02:00
noreset Add several low-level debugging tools 2021-07-30 06:38:12 +02:00
README.md elf_mem_map: remove DWARF version except in help 2021-07-30 06:38:12 +02:00
update_eeprom Add several low-level debugging tools 2021-07-30 06:38:12 +02:00

Host debugging tools for Prusa MK3 firmware

Tools

dump_eeprom

Dump the content of the entire EEPROM using the D3 command. Requires printcore from Pronterface.

dump_sram

Dump the content of the entire SRAM using the D2 command. Requires printcore from Pronterface.

elf_mem_map

Generate a symbol table map starting directly from an ELF firmware with DWARF debugging information (which is the default using the stock board definition).

When used along with a memory dump obtained from the D2 g-code, show the value of each symbol which is within the address range.

This assumes the running firmware generating the dump and the elf file are the same. Requires Python3 and the pyelftools module.

update_eeprom

Given one EEPROM dump, convert the dump to update instructions that can be sent to a printer.

Given two EEPROM dumps, produces only the required instructions needed to update the contents from the first to the second. This is currently quite crude and assumes dumps are aligned (starting from the same address or same stride).

Optionally writes the instructions to the specified port (requires printcore from Pronterface).

noreset

Set the required TTY flags on the specified port to avoid reset-on-connect for subsequent requests (issuing this command might still cause the printer to reset).