diff --git a/src/libslic3r/SupportSpotsGenerator.cpp b/src/libslic3r/SupportSpotsGenerator.cpp
index 899fe427b..5beb770f2 100644
--- a/src/libslic3r/SupportSpotsGenerator.cpp
+++ b/src/libslic3r/SupportSpotsGenerator.cpp
@@ -1231,13 +1231,13 @@ struct LayerCurlingEstimator
 
             if (fabs(dist_from_prev_layer) < 2.0f * flow_width) {
                 const ExtrusionLine &nearest_line = prev_layer_lines.get_line(nearest_line_idx);
-                current_line.malformation += 0.85 * nearest_line.malformation;
+                current_line.malformation += 0.9 * nearest_line.malformation;
             }
             if (dist_from_prev_layer > min_malformation_dist && dist_from_prev_layer < max_malformation_dist) {
-                float factor = std::abs(dist_from_prev_layer - (max_malformation_dist + min_malformation_dist) * 0.5) /
-                               (max_malformation_dist - min_malformation_dist);
+                float factor = 0.5f + 0.5f * std::abs(dist_from_prev_layer - (max_malformation_dist + min_malformation_dist) * 0.5) /
+                                          (max_malformation_dist - min_malformation_dist);
                 malformation_acc.add_distance(current_line.len);
-                current_line.malformation += l->height * factor * (2.0f + 3.0f * (malformation_acc.max_curvature / PI));
+                current_line.malformation += l->height * factor * (1.5f + 3.0f * (malformation_acc.max_curvature / PI));
                 current_line.malformation = std::min(current_line.malformation, float(l->height * params.max_malformation_factor));
             } else {
                 malformation_acc.reset();
diff --git a/src/libslic3r/SupportSpotsGenerator.hpp b/src/libslic3r/SupportSpotsGenerator.hpp
index 6cc82f4c2..6a549bd36 100644
--- a/src/libslic3r/SupportSpotsGenerator.hpp
+++ b/src/libslic3r/SupportSpotsGenerator.hpp
@@ -26,7 +26,7 @@ struct Params {
     // the algorithm should use the following units for all computations: distance [mm], mass [g], time [s], force [g*mm/s^2]
     const float bridge_distance = 12.0f; //mm
     const float bridge_distance_decrease_by_curvature_factor = 5.0f; // allowed bridge distance = bridge_distance / (1 + this factor * (curvature / PI) )
-    const std::pair<float,float> malformation_overlap_factor = std::pair<float, float> { 0.45, -0.1 };
+    const std::pair<float,float> malformation_overlap_factor = std::pair<float, float> { 0.50, -0.1 };
     const float max_malformation_factor = 10.0f;
 
     const float min_distance_between_support_points = 3.0f; //mm