both single_extruder_multi_material and wipe_tower are enabled,
and the print prints with a single extruder only.
Newly the same situation will be handled through a conditional G-code
in the following format:
{if not has_wipe_tower}
; Do the priming
{endif}
fixed crashes when loading a config.ini with "compatible_printers"
disabled export of "compatible_printers" into gcode and config.ini
Enabled compatibility of printing multiple objects with support / no support
with a wipe tower.
without being registered. Unfortunately this hack works on wxWidgets
on Windows. On OSX or Linux, a warning is emited and no accelerator
key is shown on the menu.
This commit just removes the warnings, it does not add the menu accelerators.
https://github.com/prusa3d/Slic3r/issues/539
gap created between the support and the support sheath.
Now the support sheath will overlap with the support base by 10%
of the extrusion width by default.
G-codes in case of single extruder multiple material setup:
At the start of the print, the filament_gcode_start is executed
for the active extruder only, and the filament_gcode_start /
filament_gcode_end are then executed at each tool change.
When the Prusa MM wipe tower is active, the tool changes are handled
a bit differently: M900 K0 is emited before the wipe tower extrusions start,
and the filament_gcode_start code is executed after the wipe tower extrusions
are done. This rule effectively disables the linear advance over the wipe tower.
Implements https://github.com/prusa3d/Slic3r/issues/568
I was unable to compile without ExtUtils::XSpp and ExtUtils::Typemaps .
My platform is a fresh install of OctoPi on Raspberry Pi.
I'm not sure what the `0` in those lines does.
thanks @lordofhyphens, https://github.com/alexrj/Slic3r/pull/3275
Improved handling of custom G-code blocks: Slic3r will try to extract
the target extruder and bed temperatures from the custom G-code blocks.
The incompatible presets are hidden in the tabs if show_incompatible_presets
is false. If show_incompatible_presets is true, there is a button to
show / hide the incompatible presets from the tab selector.
Removed Perl Flow::new_from_spacing bindings.
Some Fill C++11 beautification.
Fix of a support_material_1st_layer_flow, brim_flow and skirt_flow logic to use the extrusion_width if both first_layer_extrusion_width and support_material_extrusion_width are undefined.
Documented the extrusion width logic in the config tooltips, including the default values.
