There was a bug in unit tests that led to generating the wipe tower with non-normalized preset.
This caused out-of-bounds access into max_layer_height vector in fill_wipe_tower_partitions.
The problem surfaced in https://github.com/prusa3d/PrusaSlicer/issues/2288.
I quickly patched additional normalization of the preset to prevent this from happening.
Also, an assert in the same function turned out to trip on one of the tests.
This one was commented out for now and will (hopefully) be looked into later.
Function Print::apply_config was renamed to apply_config_perl_tests_only so everyone
sees its current purpose and does not mistake it for the more important Print::apply.
Removed GCode.pm
Removed the Perl bindigns for AvoidCrossingPerimeters, OozePrevention, SpiralVase, Wipe
Changed the std::set of extruder IDs to vector of IDs.
Removed some MSVC compiler warnings, removed obnoxious compiler warnings when compiling the Perl bindings.
Removed the questionable Pressure Advance feature. It is better to use the Pressure Advance implemented into a firmware.
Added a C++ implementation of GCodeReader and SpiralVase, thanks to @alexrj
Added a C++ implementation of GCodeTimeEstimator, thanks to @lordofhyphens
When extruding supports, the support is interleaved with interface
if possible (when extruded with the same extruder).
Otherwise the base is extruded first.
inside ClipperUtils are now using bit shifts instead of multiplication
by doubles, which makes the scaling precise.
Removed the scale parameter from all offset functions.
Modified the safety offset to calculate offset per polygon instead
of over all polygons at once. The old way was not safe and very slow,
sometimes this meant a kiss of death for supports for example.
These could be calculated from the fill areas if needed.
On the other side, the non-classified (non-split) fill areas are stored
now for use in the "ensure vertical wall thickness" feature,
also the non-split fill areas are re-used when recalculating the infills.
This is safer than trying to stitch the fill region together from the
classified fragments.
Modified the "ensure vertical wall thickness" feature to use the non-split
fill areas instead of perimeter areas for the calculation
of non-supported regions. This is cheaper as the fill areas contain
roughly half the edges.
Fixed some cracks in the fill surfaces created by rounding all surfaces inside detect_surface_type().
Fixed https://github.com/prusa3d/Slic3r/issues/12
Bridging-Angle not optimal
Extended the "Ensure veritcal wall thickness" mode (merged with the original discover_horizontal_shells function), but this a work in progress. Already Slic3r with "ensure vertical wall thickness" produces less spurious infills inside solids.
Removed dependency on Perl Math::PlanePath module.
Fixed compilation with Visual Studio and SLIC3R_DEBUG: Visual Studio older than 2015 does not support the prinf type specifier %zu. Use %Iu instead.
C++11 move semantics enabled.
Removed the deprecated VibrationLimit feature.
Added triangle infill.
The Prusa3D fork of Slic3r has been marked as "Slic3r Prusa Edition"
with menus pointing to the prusa3d/slic3r github release page
and Prusa3D drivers downloads page.
