Allow running the model checking during autotuning, with the only
exception being the parameter estimation stage where we alter the same
value which is used by the checker (done to conserve memory/code).
With previous changes the model checker will disable/enable itself when
passing through an unavailable R vector entry, allowing to start the
calibration by checking only the stages where the part fan is disabled.
The C/R0 values should be stable enough to provide a fail-safe mechanism
for printers of the same variant right from the factory.
Instead of assuming the model state is always valid, allow NAN values to
pass-through the various check/estimation stages.
This allows running the model checker with incomplete parameters (for
example, missing entries in the R vector) and resume automatically.
flash: -22
RAM: 0
menu_lcd_lcdupdate_func() takes care of starting lcd_timeoutToStatus if the knob is clicked.
When the knob is clicked we only want to back out of the menu.
This changes makes the menus slightly more conistant behind the scenes.
flash: -8
RAM: 0
When the menu is entered and left the function
menu_lcd_lcdupdate_func() takes care of resetting the timer.
Currently the firmware will reset the timer twice when the lcd_babystep_z menu is entered. This commit fixes that.
Split the planner sync code out of planner_abort_hard() so that we can
independently resync the planner position from the counters.
This is needed in xyzcal as we directly modify the stepper counters
(bypassing both planner and stepper).
Call this new function instead of planner_abort_hard() when leaving, so
that motion can resume in the middle of the gcode_M45 instruction.
We already disable the heaters upon entering, and the new temperature
isr doesn't perform any direct movement until we return to the main
loop.
This allows us to remove direct control of the soft_pwm interrupt from
the header, which is dangerous.
