Mark acceleration settings as experimental and add a M501 command at the end of the print if acceleration control is enabled

lib/Slic3r/GUI/SkeinPanel.pm

@@ -36,7 +36,7 @@ sub new {
             options => [qw(travel_speed bottom_layer_speed_ratio)],
         },
         acceleration => {
-            title => 'Acceleration settings',
+            title => 'Acceleration (experimental)',
             options => [qw(acceleration perimeter_acceleration infill_acceleration)],
         },
         accuracy => {

lib/Slic3r/Print.pm

@@ -521,6 +521,7 @@ sub export_gcode {
     
     # write end commands to file
     print $fh $extruder->retract;
+    print $fh "M501 ; reset acceleration\n" if $Slic3r::acceleration;
     print $fh "$Slic3r::end_gcode\n";
     
     printf $fh "; filament used = %.1fmm (%.1fcm3)\n",