numeric accuracy and to reduce compuatitonal load. With this commit,
the numeric rounding is fixed not only for the M221 G-code
(as implemented by the preceding commit), but also for the volumetric
extrusion in general.
Removed the old FILAMENT_SENSOR code, which served the purpose
to modulate the volumetric multiplayer in real time depending
on the measured filament diameter. This feature will certainly not be
used by Prusa Research in the near future as we know of no sensor,
which would offer sufficient accuracy for a reasonable price.
beyond the current time. This is a trick borrwed from upstream Marlin.
In debug mode, watch for the missed stepper interrupt ticks where the interrupts
are missed by more than 20% of the 10kHz stepper interrupt repeat rate,
and show the statistics (number of missed ticks and by how many micro
seconds was the interrupt missed, and what was the maximum missed
interrupt delay) on the display and send it to the serial line.
dcode D12 removed (no longer needed)
homeaxis optimized + xy home calibration support
new eeprom variables
new lcd menu edit types (byte3, mres, wfac), new menu "Experimental"
currents adjusted
1) The computational load is spread more evenly along the stepper ISR
ticks by moving some of the timer and linear advance calculation from
the block initialization into the 1st tick of the steady phase
of the trapezoid.
2) Reworked planning of the Linear Advance ISR ticks to fit
the time slot allocated for the main stepper ISR tick. This is achieved
by grouping the Linear Advance extruder ticks by a power of two to tick
the Linear Advance interrupts at a maximum 7kHz. Also some
of the extruder ticks are performed just after the XYZ ticks
and if the remaining time slot for the Linear Advance ticks is too short,
all the Linear Advance steps are ticked inside the main stepper ISR invocation.
3) Added some calls to MSerial.checkRx() if the stepper ISR routine
is delayed for too long by the additional LinearAdvance ticks.
This implementation differs significantly from the original implementation
by @Sebastianv650, as this implementation tries to follow the exact
timing of the XYZ axes with the drawback of possibly ticking the extruder
faster than it could handle, while the original implementation
by @Sebastianv650 ticks the extruder slower with the drawback of possibly
spreading the XYZ ticks, thus introducing jerk in the cartesian movement.
at 2 megabaud, 9bits, 1 stop bit. At this high rate the serial output
takes next to no time, so it does not slow down the debugged firmware
too much, and the data is nicely aligned with the other debug signals
on the logical analyzer screen.
Removed DEBUG_DISABLE_STARTMSGS. This macro defeats the purpose
of the build server and the build messages of the non-release builds.
Removed DEBUG_DUMP_TO_2ND_SERIAL for performance reasons.
