Disable timeouts in the XYZ/Z calibration.
Don't modify feed rate multiplier during the XYZ/Z calibration.
Support multi screen messages in the XYZ/Z calibration - "move the Z carriages up" step.
Support up to three lines in the XYZ/Z calibration messages.
Added a new message "Measuring reference height of calibration point xx of 9".
Changed the "move the Z carriages up" message to suggest rotating the knob.
Changed the "live adjust not set" message to reference the manual chapter and section.
Remove debugging serial line output on Z calibration.
Removed the non-working pressure advance feature.
Improved accuracy of diagonal moves by oversampling the path discretization.
Accelerated the planner by rewriting time critical routines from floating
point to fixed point arithmetics.
to the Z end stoppers and to re-calibrate the 9 bed point
reference values after the printer has been re-seated or transported.
New "Mesh Bed Leveling" function was added to the menu, doing what
the "Calibrate Z" was doing before.
Clean-up of some hard coded constants.
Fixed line edit error introduced in the preceding check-in.
Enable a high power mode when first booted up on a virgin RAMBo board.
1) Fix of stepper control timing
2) Load / restore baby stepping after 9 point bed leveling using
the planner instead of the questionable baby stepping routine.
Improvement of the menu system: Use a shared menuData union to preserve
memory. Adaptation of baby stepping and edit menus to menuData.
Improvement of the "Toshiba FlashAir" status display. Don't force IP
address query on each display refresh when in the "Support" menu.
Bugfix of the baby stepping menu: Show the correct value instead
of zero when the baby stepping menu is entered.
New feature: Bed leveling adjustment at left / right / front / rear side.
The bed adjustment feature is accessible from the Settings menu
and as L R F B codes of the G80 code.
"M115 Umajor.minor.revision-flavor" will trigger a dialog
on the display if the "upgrade" firmware version number is higher
than the current version number.
