Calibrate C/R values via univariate minimization using golden section.
This is done in several passes:
- Bootstrap C by setting an initial high R value
- Calibrate R at the requested working temperature
- Cooldown
- Refine C to the final value
- Estimate R losses for a subset of fan speeds
- Interpolate remaining values to speed-up the process
This results in robust values which are tailored to the current
filtering constants, and avoid having to sample for an extended
time to reach the required resolution.
The refining pass could avoid cooldown if the recording buffer was at
least twice as large, so that we could record both the heating and the
steady-state, saving _considerable_ time.
This currently bypasses the ConfigurationStore, which doesn't fit the
malin model nicely.
temp_model is using it's own private copy directly.
But maybe we should change this in the future.
- Allow all parameters to be changed at runtime through M310
- Move the model prototypes into a separate temp_model.h header
- Allow the checked to be enabled/disabled at runtime
- Introduce a warning threshold
Setting pid_tuning_finished can result in the heaters stuck to full
power. As a result, we need to ensure that when PID management is
disabled, heaters are also.
Split off setIsrTargetTemperatures and temp_mgr_pid() so that we can
propagate the target temperatures instantaneously down the pid/pwm chain
during emergencies.
This reduces the amount of code in disable_heater() itself, making it
a bit more maintenable.
The bed still isn't disabled on-the-spot yet, due to the heatbed_pwm
automaton. To be improved later.
Use a new low-priority "temp_mgr_isr" running at constant rate for
temperature management.
This is done so that the temperatures are sampled at a constant
independent interval *and* with reduced jitter. Likewise for actual
PID management.
This will require further adjustment for the min/max/runaway display,
which cannot be done directly into this function anymore (the code will
need to disable heaters but flag for display to be handled in
manage_heaters).
Partially revert previous change: cancelling a single loop would often
advance the gcode stream to the next wait-for loop if executed at the
beginning of an SD print, implicitly turning off the flag again.
Cancel the loop directly in UnconditionalStop() which stops the command
queue as well in an atomic way, handling this correctly.
Remove most of the duplicated code inside temp_runaway_stop(),
making it identical to the other temperature handlers.
Move the lower-level functions required to stop the entirety of the
machine into UnconditionalStop(). Reuse this function inside
lcd_print_stop().
Set the LCD alert message before calling Stop(), as done in other safety
handlers, so that the error is visible while the printer is stopping.
This also avoids other temporary status messages to appear before
the real issue is shown and/or STEALING the first CRITICAL alert
level before we do.
* MK3S IR sensor detection and safe operational range fix
* debug, change of fsensor_IR_check behavior
* more doc + disable debug print voltage
* fix displaying MSG_04_OR_NEWER and MSG_03.... kudos to @ovariludovit
* better handling of fsensor not responding scenario
Timing functions (millis, micros and delay) replaced in whole source, defined in Marlin.h.
This commit enables original implementation (SYSTEM_TIMER_2 undefined)
Verified with passed complete wizard process.
