Setting pid_tuning_finished can result in the heaters stuck to full
power. As a result, we need to ensure that when PID management is
disabled, heaters are also.
Use pid_tuning_finished as a flag to prevent automatic PID management.
As a result, set the default start-up state to true and adjust the
dependent code accordingly.
- Flag the error condition from the temp_mgr_isr
- Handle the error state from the user code
Currently only handles min/maxtemp and relays the error to the original
handler (which is a poor fit for the current design).
Split off setIsrTargetTemperatures and temp_mgr_pid() so that we can
propagate the target temperatures instantaneously down the pid/pwm chain
during emergencies.
This reduces the amount of code in disable_heater() itself, making it
a bit more maintenable.
The bed still isn't disabled on-the-spot yet, due to the heatbed_pwm
automaton. To be improved later.
*_temperature_raw: buffer for the ADC ISR (read by temp ISR)
*_temperature_isr: latest temperatures for PID regulation (copied from
_raw values)
*_temperature: latest temperature for user code
The flow:
- ADC ISR (async)
- perform oversampling
- call ADC callback: copy to _raw (async)
- temp ISR (timer)
- convert to C (_isr values)
- user code (async)
- check temp_meas_ready
- call updateTemperature()
- copy from _isr to current
- syncronize target temperatures
This removes PINDA value averaging (if needed, should be re-implemented
by averaging in user code where needed)
Use a new low-priority "temp_mgr_isr" running at constant rate for
temperature management.
This is done so that the temperatures are sampled at a constant
independent interval *and* with reduced jitter. Likewise for actual
PID management.
This will require further adjustment for the min/max/runaway display,
which cannot be done directly into this function anymore (the code will
need to disable heaters but flag for display to be handled in
manage_heaters).
Read from ADC as fast as possible using the ADC interrupt to get
more accurate instantaneous readings.
Decouple the temperature_isr from the adc reading interval, so that
the two can run independently for future use.
Setting pullups on the ADC should trigger the model-based check, making
this redundant and wasteful.
Keep the DEBUG_PULLUP_CRASH menu so that we can verify this behavior in
the future.
The max/min temperature check were incorrectly using
HEATER_AMBIENT_RAW_*_TEMP (non-existing) instead of the correct
AMBIENT_RAW_*_TEMP (this is not a heater afterall).
This doesn't change the current behavior, since the check defaulted to
the correct path for the MK3+ configuration anyway.
