This currently bypasses the ConfigurationStore, which doesn't fit the
malin model nicely.
temp_model is using it's own private copy directly.
But maybe we should change this in the future.
- Allow all parameters to be changed at runtime through M310
- Move the model prototypes into a separate temp_model.h header
- Allow the checked to be enabled/disabled at runtime
- Introduce a warning threshold
When triggering a thermal error, allow higher-priority errors to
override the initial error source.
This allows a fatal error such as maxtemp to trigger to a full stop even
if thermal runaway has already been triggered.
Reorder error types according to their priority.
Do not overwrite the error source if the error flag is already set.
As checks are performed in priority order, this ensures min/maxtemp
user-level handlers are triggered even if the thermal model can detect
an issue in the same cycle.
This restores MAXTEMP handling, which was simply shadowed.
Setting pid_tuning_finished can result in the heaters stuck to full
power. As a result, we need to ensure that when PID management is
disabled, heaters are also.
Use pid_tuning_finished as a flag to prevent automatic PID management.
As a result, set the default start-up state to true and adjust the
dependent code accordingly.
- Flag the error condition from the temp_mgr_isr
- Handle the error state from the user code
Currently only handles min/maxtemp and relays the error to the original
handler (which is a poor fit for the current design).
Split off setIsrTargetTemperatures and temp_mgr_pid() so that we can
propagate the target temperatures instantaneously down the pid/pwm chain
during emergencies.
This reduces the amount of code in disable_heater() itself, making it
a bit more maintenable.
The bed still isn't disabled on-the-spot yet, due to the heatbed_pwm
automaton. To be improved later.
*_temperature_raw: buffer for the ADC ISR (read by temp ISR)
*_temperature_isr: latest temperatures for PID regulation (copied from
_raw values)
*_temperature: latest temperature for user code
The flow:
- ADC ISR (async)
- perform oversampling
- call ADC callback: copy to _raw (async)
- temp ISR (timer)
- convert to C (_isr values)
- user code (async)
- check temp_meas_ready
- call updateTemperature()
- copy from _isr to current
- syncronize target temperatures
This removes PINDA value averaging (if needed, should be re-implemented
by averaging in user code where needed)
Use a new low-priority "temp_mgr_isr" running at constant rate for
temperature management.
This is done so that the temperatures are sampled at a constant
independent interval *and* with reduced jitter. Likewise for actual
PID management.
This will require further adjustment for the min/max/runaway display,
which cannot be done directly into this function anymore (the code will
need to disable heaters but flag for display to be handled in
manage_heaters).
Read from ADC as fast as possible using the ADC interrupt to get
more accurate instantaneous readings.
Decouple the temperature_isr from the adc reading interval, so that
the two can run independently for future use.
Setting pullups on the ADC should trigger the model-based check, making
this redundant and wasteful.
Keep the DEBUG_PULLUP_CRASH menu so that we can verify this behavior in
the future.
