perimeters if not necessary, don't take the bridging time into account
when slowing down the print.
Removed Extruder & GCodeWriter Perl bindings.
Improved Extruder for constness.
Refactored GCode::m_elapsed_time to struct ElapsedTime.
values to GCode generator, one per active extruder:
bed_temperature
bridge_fan_speed
cooling
disable_fan_first_layers
fan_always_on
fan_below_layer_time
first_layer_bed_temperature
max_fan_speed
min_fan_speed
min_print_speed
slowdown_below_layer_time
Now it remains to extend Slic3r to correctly apply these values.
Removed GCode.pm
Removed the Perl bindigns for AvoidCrossingPerimeters, OozePrevention, SpiralVase, Wipe
Changed the std::set of extruder IDs to vector of IDs.
Removed some MSVC compiler warnings, removed obnoxious compiler warnings when compiling the Perl bindings.
Removed the questionable Pressure Advance feature. It is better to use the Pressure Advance implemented into a firmware.
Added a C++ implementation of GCodeReader and SpiralVase, thanks to @alexrj
Added a C++ implementation of GCodeTimeEstimator, thanks to @lordofhyphens
When extruding supports, the support is interleaved with interface
if possible (when extruded with the same extruder).
Otherwise the base is extruded first.
These could be calculated from the fill areas if needed.
On the other side, the non-classified (non-split) fill areas are stored
now for use in the "ensure vertical wall thickness" feature,
also the non-split fill areas are re-used when recalculating the infills.
This is safer than trying to stitch the fill region together from the
classified fragments.
Modified the "ensure vertical wall thickness" feature to use the non-split
fill areas instead of perimeter areas for the calculation
of non-supported regions. This is cheaper as the fill areas contain
roughly half the edges.
direction over multiple regions. This allows a single bridge to be
drawn over holes, which are too close to each other to allow
for separate bridges.
Fixes Bridging-Angle not optimal
https://github.com/prusa3d/Slic3r/issues/12
Re-allowed adaptive infill line width for solid infills. The adaptive
infill line width works in some circumstances, see Issue #15,
but the original implementation often changed the line width too
aggressively. The current implementation limits the line width change
to 20%.
Fixes Gaps between infill and perimeter leads to errors in laydown on following layer
https://github.com/prusa3d/Slic3r/issues/15
Removed dependency on Perl Math::PlanePath module.
Fixed compilation with Visual Studio and SLIC3R_DEBUG: Visual Studio older than 2015 does not support the prinf type specifier %zu. Use %Iu instead.
C++11 move semantics enabled.
Removed the deprecated VibrationLimit feature.
Added triangle infill.
The Prusa3D fork of Slic3r has been marked as "Slic3r Prusa Edition"
with menus pointing to the prusa3d/slic3r github release page
and Prusa3D drivers downloads page.
