Drain holes are not allowed to be placed on its own inner surface. This was recently (0e3ebb3)
done by forcing invalidation of the slaposDrillHoles, which also invalidates and therefore
hides the drilled mesh. However, that also hides the hollowed mesh and it is not possible
to place holes inside the cavity.
This change does not dump the drilled mesh, but checks that no raycast hit ends up in a hole.
printer configuration:
ss -> sm : Just apply the color changes of the original ss project at the active extruder.
ss -> mm : There are no tool changes stored. Ignore color changes, they are invalid because they are extruder non-specific.
sm -> ss : Apply tool changes as color changes (tool changes remember the target color), apply original color changes.
sm -> mm : Ignore both color changes and tool changes.
mm -> ss/sm : Ignore both color changes and tool changes.
show just the label in the application title. For Win32, add the
" 32 bit" indicator, so that we may see clearly if somebody is running
a 32bit build on 64bit windows by a mistake.
The two new config keys define a minimum vertical shell thickness.
The top shell thickness is calculated as a maximum of sum over
top_solid_layers * layer heights and top_solid_min_thickness,
the bottom shell thickness is calculated as a maximum of sum over
bottom_solid_layers * layer heights and bottom_solid_min_thickness.
The results of the formula above are shown at the Print parameter page
below the two new values to hint the user about the interaction
of the old versus new config values.
top_solid_min_thickness has no meaning if top_solid_layers is zero,
bottom_solid_min_thickness has no meaning if bottom_solid_layers is zero.
by the PlaceholderParser.
Namely, all the options with the "ratio_over" reference are now handled
correctly by the PlaceholderParser with the exception
of the "first_layer_extrusion_width", which overrides speed of extrusions
by their respective extrusion type.
Also the various extrusion widths (extrusion_width, first_layer_extrusion_width,
external_perimeter_extrusion_width etc.) produce the same numbers
as if ran through the back-end, with the assumption of not overriding
layer height by the variable layer height editing tool or layer height
modifiers.
